Another Fiat 500

[Red_ufo]

This is my first reel 3D project, and this is what I have did so far pretty good I think…cheers

[Red_ufo]

Another angle.

[Red_ufo]

Here is a wire frame.

[Ravens]

Pretty nice done :D i aint there yet :) restarted few times :D
look at my RAce version :D

[JQuacker]

Good smooth work :) I envy you guys, I could never get that ridge down the side to come out nicely (you can see mine on my website; link in my sig)

[Red_ufo]

Just an update on the state of play with the Fiat 500, no pictures, just a peace of advice to all. If you are ever doing a chamfer or extruding a line, always chamfer the line before extruding a line that joins the chamfer, it saves hole lot bother, It took me four blasted days to learn that lesson.

Sorry for venting my frustrations here, it's better that than throwing the computer out the window......go in peace

[Red_ufo]

This is what I have did so far, all most finished the door still to adjust the window a bit, I must confess there was one or two mesh error's, at one point I thought I would have to start all over again but I found It quiet easy to fix.
I am happy with the results so far...cheers

[Red_ufo]

and another.

[Red_ufo]

and a third.

[Red_ufo]

and here is a wire frame of the door.

[Red_ufo]

This is a bit of a downer of an update, my system is still a bit sluggish but after what happened, a power surge It completely wiped the hardrive fortunately I know a little about restoring systems.

Fait 500, DB9 and a Eurofighter, gone. It completely sucks. It just makes me that bit more determined....cheers

[Red_ufo]

I had to start my Fiat 500 mesh again after a hardrive crash, I think as you can see by the images of my first attempted the Fiat 500 It’s a lot better than the first attempt, several images from different angles one with a meshsmooth, one without and a wire frame, comments please…..cheers

[Red_ufo]

And the second

[Red_ufo]

And a wireframe

[Red_ufo]

and here is another

[Red_ufo]

and another

[Red_ufo]

Well this is my latest update, I think it looks pretty dame good for a novas, but opinions matter what do you think, I know the roof needs a little work, still but overall it looks good…cheers

[Red_ufo]

And here is a second.

[Red_ufo]

Well I fixed the roof cover somewhat, but I will admit the car dose look a lot better than it did, I’ve also fixed the edge of the rime above the door, it still needs the vertices tweaked here and there to get the into the right position but overall I am happy with what I’ve did so far…..cheers

[Red_ufo]

Here’s another view.

[Red_ufo]

at the moment I am working on the interior of the Fiat, I was doing a little experiment at joining both half's of the mesh as well, judging by the results I think it was a success.

In one pic you can see the line that separates the two sides of the mesh, in the other the line is gone, what do you think.....cheers

[Red_ufo]

And the other pic.