lickuid
21-06-2007, 10:40 PM
I Figured this one out... very simple, for anyone who may wonder the same thing:
you have to be in a lower subdivision. Click on the button to make the deformation and it will take the detail data from the higher subdivision and send it to the alpha pallette.
Note before you start with the details, store your original mesh into a morph target. Then after you've finished your details, revert to the lowest subdivision then slide the morph slider all the way to the right, this will reset the lowest subdivision back to how it was before you started moving vertexes around. Then click on create displacement.
you have to be in a lower subdivision. Click on the button to make the deformation and it will take the detail data from the higher subdivision and send it to the alpha pallette.
Note before you start with the details, store your original mesh into a morph target. Then after you've finished your details, revert to the lowest subdivision then slide the morph slider all the way to the right, this will reset the lowest subdivision back to how it was before you started moving vertexes around. Then click on create displacement.