View Full Version : SMC M#04- Xeni- Mini Solar Drilling Machine
Hi this is my firts time i am enterin for the 'speed modelling'
I have create a sketch Mini drilling machine.
I hope you like the sketch.
i just created modeling
04-02-2010, 07:45 PM
Interesting start, and a fellow Cinema 4D user too :) Good to see. Good luck with the model!
04-02-2010, 08:47 PM
Good start man. We are both doing similar concepts. I tried using Cinema 4D for modeling and Failed Hard. SO now i only use it for BodyPaint3D
Thanks you form the nice comments 'ClassicGamer-3DT' and 'TNTxGRAVE' :), yes i am using cinema 4d r11.5.
30 min creating the drilling
i hope you like it sofar :)
06-02-2010, 07:01 PM
I know this isn't a modeling efficiency challenge but some of the geometry you have isn't needed. reducing your poly count on certain objects like the cylinders on the drill and the hydraulic pumps and the control levers will make it easier for you to work. but over all your shapes and modeling look good buddy
07-02-2010, 04:07 PM
so far so good. looks like those bobcats.
All together 239 min, there are loads of polygons, in the model i have used 'symetry, Sweep Nurbs, HyperNURBS, Boole and Array,' some of them i have dublicate.
1st image there are 4 difrenet view of the drilling machine. 'Wireframes'
2nd image there are 4 difrenet view of the drilling machine. 'Sketch and Toon' from Cinema 4d.
I hope you like it.
08-02-2010, 02:05 PM
nice model. well done. i like the shaded mode :) . looks like the image from some sort of manual :) .
14-02-2010, 07:34 PM
Great progress :)
thanks you 'paulius-st and ClassicGamer-3DT'
28-02-2010, 08:02 AM
very nice, I like the toon shader, like paulius-st said, is like from an manual.
thanks for the comment 'hammering3D'
vBulletin® v3.7.4, Copyright ©2000-2013, Jelsoft Enterprises Ltd.