3DTotal Forums - View Single Post - The SMC's - #79

rocneasta · 31-10-2009, 06:00 PM

this model was far easier to make, had really good reference photos, and i devoted some of the time to actually make the setting of the fair - fence, steps booth...

hope you get the craving for the rides as i did while modeling

p.s. i did the chains to hold the chairs - made two, the rest were to be added along the line that connected the chair and the pivot point of the carousel. for the chair closest to the carousel pillar i had 386 chain pieces times 4 since 4 of them are holding the chair in place. Unfortunately the need for resources went up, so i was forced to only connect them with a thin cylinder that represents rubber. not the best solution since those chains really give authenticity. but i'll try to do it when i have an entire day to process it, or when i get a better spec to play with...

31-10-2009, 06:00 PM	#31
rocneasta in search of excellence Join Date: Nov 2008 Location: 25m2 flat Posts: 5,305 Thanks: 111 Thanked 393 Times in 352 Posts Awards Showcase Total Awards: 31	this model was far easier to make, had really good reference photos, and i devoted some of the time to actually make the setting of the fair - fence, steps booth... hope you get the craving for the rides as i did while modeling p.s. i did the chains to hold the chairs - made two, the rest were to be added along the line that connected the chair and the pivot point of the carousel. for the chair closest to the carousel pillar i had 386 chain pieces times 4 since 4 of them are holding the chair in place. Unfortunately the need for resources went up, so i was forced to only connect them with a thin cylinder that represents rubber. not the best solution since those chains really give authenticity. but i'll try to do it when i have an entire day to process it, or when i get a better spec to play with... Attached Images Last edited by rocneasta; 01-11-2009 at 07:06 AM..