how to model the air hole of the car?

jerrylong · 29-11-2004, 01:58 PM

I want to model the air hole of the car

this is my wireframe(before subdiv)

this is subdivided model

how to avoid the line marked by the red circle?

Morzog · 29-11-2004, 06:52 PM

When you put two edges close together Max thinks you want a hard edge. If you want that part to be smooth remove one of the edges so there is just one edge there and not two.

jerrylong · 30-11-2004, 05:25 AM

thanks morzog, it works, very simple

29-11-2004, 01:58 PM	#1
jerrylong Registered User Join Date: Aug 2004 Posts: 3 Thanks: 0 Thanked 0 Times in 0 Posts	how to model the air hole of the car? I want to model the air hole of the car this is my wireframe(before subdiv) this is subdivided model how to avoid the line marked by the red circle?

30-11-2004, 05:25 AM	#3
jerrylong Registered User Join Date: Aug 2004 Posts: 3 Thanks: 0 Thanked 0 Times in 0 Posts	solved the problem thanks morzog, it works, very simple

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

29-11-2004, 06:52 PM	#2
Morzog Registered User Join Date: Jul 2003 Location: Canada Posts: 168 Thanks: 0 Thanked 0 Times in 0 Posts	When you put two edges close together Max thinks you want a hard edge. If you want that part to be smooth remove one of the edges so there is just one edge there and not two.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)