Circular Fillet and triming make gaps between 2 surfaces

rippedangelwing · 30-11-2005, 11:14 AM

I create two CV Curves and then I loft them with default settings. Then I Circular fillet the lofted surface with a plane I have created before (default settings) and then I trim the two surfaces, so that I can keep the parts that I need. The two surfaces between them have gaps. why is that?

In the NURBS Tessalation I put everything to maximum. And I still get the same results. Is something in the whole process that I am doing wrong? Am I doing something wrong? If I change a specific setting, will that have better results? And Something else, how can I attach two trimmed surfaces?

I would appreciate an answer! thank you!

rippedangelwing · 30-11-2005, 11:16 AM

I forgot to mention what software I am using. Its MAYA 7

30-11-2005, 11:14 AM	#1
rippedangelwing Registered User Join Date: Nov 2005 Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts	Circular Fillet and triming make gaps between 2 surfaces I create two CV Curves and then I loft them with default settings. Then I Circular fillet the lofted surface with a plane I have created before (default settings) and then I trim the two surfaces, so that I can keep the parts that I need. The two surfaces between them have gaps. why is that? In the NURBS Tessalation I put everything to maximum. And I still get the same results. Is something in the whole process that I am doing wrong? Am I doing something wrong? If I change a specific setting, will that have better results? And Something else, how can I attach two trimmed surfaces? I would appreciate an answer! thank you!

30-11-2005, 11:16 AM	#2
rippedangelwing Registered User Join Date: Nov 2005 Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts	I Use Maya 7 I forgot to mention what software I am using. Its MAYA 7

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)