View Single Post
Old 10-01-2014, 03:13 PM   #8
Registered User
Join Date: Jan 2014
Location: Perth, Australia
Posts: 32
Thanks: 0
Thanked 3 Times in 2 Posts
Hi Mcfly,

Thanks for the feedback, you have explained it perfectly. I have drifted from the original reference images quite a bit but it was mostly intentional I wanted to try and make the model a bit more interesting to look at.

The hard edges around the side pocket and below the pocket im intending to make plastic, do you mean the support edges around the bag itself, if so then yes I can see what you mean I need to widen the support lines to give it a more rolled over softer edge I totally agree.

I will try and make some amendments based on your comments.

Thanks again

SnakeHipsUK is offline   Reply With Quote